![]() Every time we had bayonet fighting sessions, we would wrap our personal issue of green army towel around the thin Bakelite hand guard of the rifle so that. The kit comes with pre-cut pieces, 3” x 29” barrel, 7” x 10” receiver, 7” x 19” forend, and two pieces for the butt-stock. #Rifle handguard wrap skin#įor irregular shaped butt-stocks or other accessories, you will want to use a Large Gear Skin instead. Why will the GunSkin not stick to my gun/accessory? You must thoroughly clean the gun/accessory before installing the GunSkin. ![]() We use a gun-specific degreaser and a small brush. ![]() Make sure to scrub all the recessed areas to remove oil and dirt. Then wipe it off, or with some parts you can rinse with warm water and let dry. Newer guns tend to be more oily, so you might need to clean it twice. Before installing, you can use rubbing alcohol to wipe off any dust or debris. Also, make sure to use heat as your installing the GunSkin, it helps the material to conform. Can the GunSkin be removed? GunSkins are removable and have no effect on the finish. To remove the GunSkin, heat the material with a heat gun/blow dryer and peel off. If there is any residue left behind, use rubbing alcohol or Goo Gone to remove. Will heat from the barrel melt the GunSkin? The heat from the barrel will not effect the GunSkin. However, we do not recommend installing the GunSkin on the barrel, if you intend on using full auto.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |